imx: power-domain: Fix crash due to uninitialized 'id' field

In case of the i.MX8M power-domains (i.MX8MQ, MM, MN) there is only
one power-domain for each device. Therefore the 'id' field in struct
power_domain should always be zero.

Currently if a power-domain is accessed after the initial bind, the
'id' field is left uninitialized. This didn't cause any problems
until the following commits were introduced:

9086b64ca0 ("power-domain: Add support for refcounting (again)")
a785ef2448 ("imx: power-domain: Enable refcounting on imx8mp")

Now the 'id' field gets accessed in the power_domain_off() sequence
and the invalid value causes "Synchronous Abort" failures.

This was observed on a i.MX8MM board when running "usb start" and
then "usb stop".

Fix this issue by setting power_domain->id to '0' in
imx8m_power_domain_of_xlate().

Signed-off-by: Frieder Schrempf <frieder.schrempf@kontron.de>
Fixes: d08a194871 ("imx: add support for i.MX8MQ power domain controller")
Fixes: 9086b64ca0 ("power-domain: Add support for refcounting (again)")
Reviewed-by: Miquel Raynal <miquel.raynal@bootlin.com>

drivers/power/domain/imx8m-power-domain.c

@@ -468,6 +468,8 @@ out_clk_disable:
 static int imx8m_power_domain_of_xlate(struct power_domain *power_domain,
 				      struct ofnode_phandle_args *args)
 {
+	power_domain->id = 0;
+
 	return 0;
 }