Merge trivial low-risk suspend hotkey bugzilla-5918 into release

drivers/pci/hotplug/Kconfig

@@ -76,7 +76,7 @@ config HOTPLUG_PCI_IBM
 
 config HOTPLUG_PCI_ACPI
 	tristate "ACPI PCI Hotplug driver"
-	depends on ACPI_DOCK && HOTPLUG_PCI
+	depends on (!ACPI_DOCK && ACPI && HOTPLUG_PCI) || (ACPI_DOCK && HOTPLUG_PCI)
 	help
 	  Say Y here if you have a system that supports PCI Hotplug using
 	  ACPI.

drivers/pci/quirks.c

@@ -1518,6 +1518,63 @@ static void __devinit quirk_netmos(struct pci_dev *dev)
 }
 DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_NETMOS, PCI_ANY_ID, quirk_netmos);
 
+static void __devinit quirk_e100_interrupt(struct pci_dev *dev)
+{
+	u16 command;
+	u32 bar;
+	u8 __iomem *csr;
+	u8 cmd_hi;
+
+	switch (dev->device) {
+	/* PCI IDs taken from drivers/net/e100.c */
+	case 0x1029:
+	case 0x1030 ... 0x1034:
+	case 0x1038 ... 0x103E:
+	case 0x1050 ... 0x1057:
+	case 0x1059:
+	case 0x1064 ... 0x106B:
+	case 0x1091 ... 0x1095:
+	case 0x1209:
+	case 0x1229:
+	case 0x2449:
+	case 0x2459:
+	case 0x245D:
+	case 0x27DC:
+		break;
+	default:
+		return;
+	}
+
+	/*
+	 * Some firmware hands off the e100 with interrupts enabled,
+	 * which can cause a flood of interrupts if packets are
+	 * received before the driver attaches to the device.  So
+	 * disable all e100 interrupts here.  The driver will
+	 * re-enable them when it's ready.
+	 */
+	pci_read_config_word(dev, PCI_COMMAND, &command);
+	pci_read_config_dword(dev, PCI_BASE_ADDRESS_0, &bar);
+
+	if (!(command & PCI_COMMAND_MEMORY) || !bar)
+		return;
+
+	csr = ioremap(bar, 8);
+	if (!csr) {
+		printk(KERN_WARNING "PCI: Can't map %s e100 registers\n",
+			pci_name(dev));
+		return;
+	}
+
+	cmd_hi = readb(csr + 3);
+	if (cmd_hi == 0) {
+		printk(KERN_WARNING "PCI: Firmware left %s e100 interrupts "
+			"enabled, disabling\n", pci_name(dev));
+		writeb(1, csr + 3);
+	}
+
+	iounmap(csr);
+}
+DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_INTEL, PCI_ANY_ID, quirk_e100_interrupt);
 
 static void __devinit fixup_rev1_53c810(struct pci_dev* dev)
 {