forked from OERV-BSP/u-boot
7d8c3fa26c
SPL_TEXT_BASE is used as the load address for the main domain SPL on k3 platforms. Since the config value is the same for every board, this patch sets the value 0x80080000 as default for all 64-bit ARCH_K3, 0x43c00000 as default for the R5 cores and deletes the instances of SPL_TEXT_BASE in individual defconfigs. Signed-off-by: Anshul Dalal <anshuld@ti.com> Reviewed-by: Tom Rini <trini@konsulko.com>
180 lines
4.6 KiB
Plaintext
180 lines
4.6 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARM_SMCCC=y
|
|
CONFIG_ARCH_K3=y
|
|
CONFIG_SYS_MALLOC_LEN=0x2000000
|
|
CONFIG_SYS_MALLOC_F_LEN=0x8000
|
|
CONFIG_SPL_GPIO=y
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_SOC_K3_AM625=y
|
|
CONFIG_PHYTEC_SOM_DETECTION=y
|
|
CONFIG_TARGET_PHYCORE_AM62X_A53=y
|
|
CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
|
|
CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x80b80000
|
|
CONFIG_SF_DEFAULT_SPEED=25000000
|
|
CONFIG_ENV_SIZE=0x20000
|
|
CONFIG_ENV_OFFSET=0x680000
|
|
CONFIG_ENV_SECT_SIZE=0x20000
|
|
CONFIG_DM_GPIO=y
|
|
CONFIG_SPL_DM_SPI=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="ti/k3-am625-phyboard-lyra-rdk"
|
|
CONFIG_OF_LIBFDT_OVERLAY=y
|
|
CONFIG_DM_RESET=y
|
|
CONFIG_SPL_MMC=y
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_SPL_DRIVERS_MISC=y
|
|
CONFIG_SPL_STACK_R_ADDR=0x83000000
|
|
CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
|
|
CONFIG_SPL_BSS_START_ADDR=0x80c80000
|
|
CONFIG_SPL_BSS_MAX_SIZE=0x80000
|
|
CONFIG_SPL_STACK_R=y
|
|
CONFIG_SYS_BOOTM_LEN=0x800000
|
|
CONFIG_SPL_SIZE_LIMIT=0x80000
|
|
CONFIG_SPL_SIZE_LIMIT_PROVIDE_STACK=0x800
|
|
CONFIG_ENV_OFFSET_REDUND=0x6c0000
|
|
CONFIG_SPL_FS_FAT=y
|
|
CONFIG_SPL_LIBDISK_SUPPORT=y
|
|
CONFIG_SPL_SPI_FLASH_SUPPORT=y
|
|
CONFIG_SPL_SPI=y
|
|
# CONFIG_PSCI_RESET is not set
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_EFI_SET_TIME=y
|
|
CONFIG_EFI_CAPSULE_ON_DISK=y
|
|
CONFIG_EFI_CAPSULE_FIRMWARE_RAW=y
|
|
CONFIG_SPL_LOAD_FIT=y
|
|
CONFIG_SPL_LOAD_FIT_ADDRESS=0x81000000
|
|
CONFIG_BOOTSTD_FULL=y
|
|
CONFIG_OF_BOARD_SETUP=y
|
|
CONFIG_BOOTCOMMAND="run ${boot}boot; bootflow scan -lb"
|
|
CONFIG_DEFAULT_FDT_FILE="oftree"
|
|
CONFIG_BOARD_LATE_INIT=y
|
|
CONFIG_SPL_MAX_SIZE=0x58000
|
|
CONFIG_SPL_SYS_REPORT_STACK_F_USAGE=y
|
|
CONFIG_SPL_BOARD_INIT=y
|
|
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
|
|
CONFIG_SPL_SYS_MMCSD_RAW_MODE=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x1400
|
|
CONFIG_SPL_DMA=y
|
|
CONFIG_SPL_ENV_SUPPORT=y
|
|
CONFIG_SPL_ETH=y
|
|
CONFIG_SPL_FS_LOAD_PAYLOAD_NAME="u-boot.img"
|
|
CONFIG_SPL_I2C=y
|
|
CONFIG_SPL_DM_MAILBOX=y
|
|
CONFIG_SPL_DM_SPI_FLASH=y
|
|
CONFIG_SPL_NET=y
|
|
CONFIG_SPL_NET_VCI_STRING="AM62X U-Boot A53 SPL"
|
|
CONFIG_SPL_POWER_DOMAIN=y
|
|
CONFIG_SPL_RAM_DEVICE=y
|
|
# CONFIG_SPL_SPI_FLASH_TINY is not set
|
|
CONFIG_SPL_SPI_FLASH_SFDP_SUPPORT=y
|
|
CONFIG_SPL_SPI_LOAD=y
|
|
CONFIG_SYS_SPI_U_BOOT_OFFS=0x280000
|
|
CONFIG_SPL_YMODEM_SUPPORT=y
|
|
# CONFIG_CMD_BOOTEFI_HELLO is not set
|
|
CONFIG_CMD_BOOTEFI_SELFTEST=y
|
|
CONFIG_CMD_NVEDIT_EFI=y
|
|
CONFIG_CMD_DFU=y
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_MTD=y
|
|
CONFIG_CMD_REMOTEPROC=y
|
|
CONFIG_CMD_USB=y
|
|
CONFIG_CMD_CACHE=y
|
|
CONFIG_CMD_EFIDEBUG=y
|
|
CONFIG_CMD_RTC=y
|
|
CONFIG_CMD_SMC=y
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_SPL_OF_CONTROL=y
|
|
CONFIG_OF_OVERLAY_LIST="ti/k3-am6xx-phycore-disable-spi-nor ti/k3-am6xx-phycore-disable-rtc ti/k3-am6xx-phycore-disable-eth-phy ti/k3-am6xx-phycore-qspi-nor"
|
|
CONFIG_MULTI_DTB_FIT=y
|
|
CONFIG_SPL_MULTI_DTB_FIT=y
|
|
CONFIG_SPL_MULTI_DTB_FIT_NO_COMPRESSION=y
|
|
CONFIG_ENV_OVERWRITE=y
|
|
CONFIG_ENV_IS_NOWHERE=y
|
|
CONFIG_ENV_IS_IN_MMC=y
|
|
CONFIG_ENV_IS_IN_SPI_FLASH=y
|
|
CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
|
|
CONFIG_SYS_MMC_ENV_DEV=1
|
|
CONFIG_NET_RANDOM_ETHADDR=y
|
|
CONFIG_SPL_DM=y
|
|
CONFIG_SPL_DM_SEQ_ALIAS=y
|
|
CONFIG_REGMAP=y
|
|
CONFIG_SPL_REGMAP=y
|
|
CONFIG_SPL_SYSCON=y
|
|
CONFIG_SPL_OF_TRANSLATE=y
|
|
CONFIG_CLK=y
|
|
CONFIG_SPL_CLK=y
|
|
CONFIG_CLK_TI_SCI=y
|
|
CONFIG_DFU_MMC=y
|
|
CONFIG_DFU_MTD=y
|
|
CONFIG_DFU_RAM=y
|
|
CONFIG_SYS_DFU_DATA_BUF_SIZE=0x40000
|
|
CONFIG_SYS_DFU_MAX_FILE_SIZE=0x800000
|
|
CONFIG_DMA_CHANNELS=y
|
|
CONFIG_TI_K3_NAVSS_UDMA=y
|
|
CONFIG_TI_SCI_PROTOCOL=y
|
|
CONFIG_DA8XX_GPIO=y
|
|
CONFIG_DM_I2C=y
|
|
CONFIG_SYS_I2C_OMAP24XX=y
|
|
CONFIG_DM_MAILBOX=y
|
|
CONFIG_K3_SEC_PROXY=y
|
|
CONFIG_SUPPORT_EMMC_BOOT=y
|
|
CONFIG_MMC_SDHCI=y
|
|
CONFIG_MMC_SDHCI_ADMA=y
|
|
CONFIG_SPL_MMC_SDHCI_ADMA=y
|
|
CONFIG_MMC_SDHCI_AM654=y
|
|
CONFIG_MTD=y
|
|
CONFIG_DM_MTD=y
|
|
CONFIG_DM_SPI_FLASH=y
|
|
CONFIG_SPI_FLASH_SFDP_SUPPORT=y
|
|
# CONFIG_SPI_FLASH_SMART_HWCAPS is not set
|
|
CONFIG_SPI_FLASH_SOFT_RESET=y
|
|
CONFIG_SPI_FLASH_SOFT_RESET_ON_BOOT=y
|
|
CONFIG_SPI_FLASH_STMICRO=y
|
|
CONFIG_SPI_FLASH_MT35XU=y
|
|
CONFIG_SPI_FLASH_MTD=y
|
|
CONFIG_PHY_TI_DP83867=y
|
|
CONFIG_PHY_FIXED=y
|
|
CONFIG_TI_AM65_CPSW_NUSS=y
|
|
CONFIG_PHY=y
|
|
CONFIG_PINCTRL=y
|
|
CONFIG_SPL_PINCTRL=y
|
|
CONFIG_PINCTRL_SINGLE=y
|
|
CONFIG_POWER_DOMAIN=y
|
|
CONFIG_TI_SCI_POWER_DOMAIN=y
|
|
CONFIG_K3_SYSTEM_CONTROLLER=y
|
|
CONFIG_REMOTEPROC_TI_K3_ARM64=y
|
|
CONFIG_RESET_TI_SCI=y
|
|
CONFIG_DM_RTC=y
|
|
CONFIG_RTC_RV3028=y
|
|
CONFIG_DM_SERIAL=y
|
|
CONFIG_SOC_DEVICE=y
|
|
CONFIG_SOC_DEVICE_TI_K3=y
|
|
CONFIG_SOC_TI=y
|
|
CONFIG_SPI=y
|
|
CONFIG_DM_SPI=y
|
|
CONFIG_CADENCE_QSPI=y
|
|
CONFIG_SYSRESET=y
|
|
CONFIG_SPL_SYSRESET=y
|
|
CONFIG_SYSRESET_TI_SCI=y
|
|
CONFIG_USB=y
|
|
CONFIG_DM_USB_GADGET=y
|
|
CONFIG_SPL_DM_USB_GADGET=y
|
|
CONFIG_USB_XHCI_HCD=y
|
|
CONFIG_USB_XHCI_DWC3=y
|
|
CONFIG_USB_DWC3=y
|
|
CONFIG_USB_DWC3_GENERIC=y
|
|
CONFIG_SPL_USB_DWC3_GENERIC=y
|
|
CONFIG_SPL_USB_DWC3_AM62=y
|
|
CONFIG_USB_DWC3_AM62=y
|
|
CONFIG_USB_GADGET=y
|
|
CONFIG_SPL_USB_GADGET=y
|
|
CONFIG_USB_GADGET_MANUFACTURER="PHYTEC"
|
|
CONFIG_USB_GADGET_VENDOR_NUM=0x0451
|
|
CONFIG_USB_GADGET_PRODUCT_NUM=0x6165
|
|
CONFIG_USB_GADGET_DOWNLOAD=y
|
|
CONFIG_SPL_DFU=y
|
|
CONFIG_FS_FAT_MAX_CLUSTSIZE=16384
|
|
# CONFIG_HEXDUMP is not set
|