forked from OERV-BSP/u-boot
3f19062d46
Judith Mendez <jm@ti.com> says: Some K3 devices like am62x and am64x have a M4 processor in the MCU voltage domain. This patch series introduces remoteproc M4 driver which will be used to load firmware into and start the M4 remote core. This series also adds support for R5F cores on am64x SoCs in patch 2 and sets up environment to load FW in remote cores in patch 3,4,5. This patch series also enables remoteproc drivers by default as per what remoteproc sybsystem is supported per SoC, thus all remoteproc options are now deleted in configs/* since they are no longer required. This patch series was tested on am64x EVM, am62x SK, am62ax SK, am62px SK boards. Any additional tested by's are welcome since I was not able to test any additional boards. Tested by running the following commands in u-boot prompt: => setenv dorprocboot 1 => run boot_rprocs Link: https://lore.kernel.org/r/20250210202944.1071931-1-jm@ti.com
140 lines
3.6 KiB
Plaintext
140 lines
3.6 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_K3=y
|
|
CONFIG_SYS_MALLOC_F_LEN=0x8000
|
|
CONFIG_SPL_GPIO=y
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_SOC_K3_AM625=y
|
|
CONFIG_TARGET_AM625_A53_EVM=y
|
|
CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
|
|
CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x80b80000
|
|
CONFIG_SF_DEFAULT_SPEED=25000000
|
|
CONFIG_DM_GPIO=y
|
|
CONFIG_SPL_DM_SPI=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="ti/k3-am625-sk"
|
|
CONFIG_SPL_TEXT_BASE=0x80080000
|
|
CONFIG_OF_LIBFDT_OVERLAY=y
|
|
CONFIG_DM_RESET=y
|
|
CONFIG_SPL_MMC=y
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_SPL_STACK_R_ADDR=0x82000000
|
|
CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
|
|
CONFIG_SPL_BSS_START_ADDR=0x80c80000
|
|
CONFIG_SPL_BSS_MAX_SIZE=0x80000
|
|
CONFIG_SPL_STACK_R=y
|
|
CONFIG_SPL_SIZE_LIMIT=0x40000
|
|
CONFIG_SPL_SIZE_LIMIT_PROVIDE_STACK=0x800
|
|
CONFIG_SPL_FS_FAT=y
|
|
CONFIG_SPL_LIBDISK_SUPPORT=y
|
|
CONFIG_SPL_SPI_FLASH_SUPPORT=y
|
|
CONFIG_SPL_SPI=y
|
|
# CONFIG_PSCI_RESET is not set
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL_LOAD_FIT=y
|
|
CONFIG_SPL_LOAD_FIT_ADDRESS=0x81000000
|
|
CONFIG_BOOTSTD_FULL=y
|
|
CONFIG_BOOTCOMMAND="run findfdt; run envboot; bootflow scan -lb"
|
|
CONFIG_BOARD_LATE_INIT=y
|
|
CONFIG_SPL_MAX_SIZE=0x58000
|
|
CONFIG_SPL_SYS_REPORT_STACK_F_USAGE=y
|
|
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
|
|
CONFIG_SPL_SYS_MMCSD_RAW_MODE=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x1400
|
|
CONFIG_SPL_ENV_SUPPORT=y
|
|
CONFIG_SPL_FS_LOAD_PAYLOAD_NAME="u-boot.img"
|
|
CONFIG_SPL_I2C=y
|
|
CONFIG_SPL_DM_MAILBOX=y
|
|
CONFIG_SPL_DM_SPI_FLASH=y
|
|
CONFIG_SPL_POWER_DOMAIN=y
|
|
# CONFIG_SPL_SPI_FLASH_TINY is not set
|
|
CONFIG_SPL_SPI_FLASH_SFDP_SUPPORT=y
|
|
CONFIG_SPL_SPI_LOAD=y
|
|
CONFIG_SYS_SPI_U_BOOT_OFFS=0x280000
|
|
CONFIG_SPL_YMODEM_SUPPORT=y
|
|
CONFIG_CMD_BOOTEFI_SELFTEST=y
|
|
CONFIG_CMD_NVEDIT_EFI=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_EFIDEBUG=y
|
|
CONFIG_MMC_SPEED_MODE_SET=y
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_SPL_OF_CONTROL=y
|
|
CONFIG_OF_UPSTREAM=y
|
|
CONFIG_MULTI_DTB_FIT=y
|
|
CONFIG_SPL_MULTI_DTB_FIT=y
|
|
CONFIG_SPL_MULTI_DTB_FIT_NO_COMPRESSION=y
|
|
CONFIG_NET_RANDOM_ETHADDR=y
|
|
CONFIG_SPL_DM=y
|
|
CONFIG_SPL_DM_DEVICE_REMOVE=y
|
|
CONFIG_SPL_DM_SEQ_ALIAS=y
|
|
CONFIG_REGMAP=y
|
|
CONFIG_SPL_REGMAP=y
|
|
CONFIG_SPL_OF_TRANSLATE=y
|
|
CONFIG_CLK=y
|
|
CONFIG_SPL_CLK=y
|
|
CONFIG_CLK_TI_SCI=y
|
|
CONFIG_DFU_SF=y
|
|
CONFIG_DMA_CHANNELS=y
|
|
CONFIG_TI_K3_NAVSS_UDMA=y
|
|
CONFIG_TI_SCI_PROTOCOL=y
|
|
CONFIG_SPL_DM_GPIO_LOOKUP_LABEL=y
|
|
CONFIG_DA8XX_GPIO=y
|
|
CONFIG_DM_PCA953X=y
|
|
CONFIG_SPL_DM_PCA953X=y
|
|
CONFIG_DM_I2C=y
|
|
CONFIG_SYS_I2C_OMAP24XX=y
|
|
CONFIG_DM_MAILBOX=y
|
|
CONFIG_K3_SEC_PROXY=y
|
|
CONFIG_SUPPORT_EMMC_BOOT=y
|
|
CONFIG_MMC_IO_VOLTAGE=y
|
|
CONFIG_SPL_MMC_IO_VOLTAGE=y
|
|
CONFIG_MMC_UHS_SUPPORT=y
|
|
CONFIG_SPL_MMC_UHS_SUPPORT=y
|
|
CONFIG_MMC_HS200_SUPPORT=y
|
|
CONFIG_SPL_MMC_HS200_SUPPORT=y
|
|
CONFIG_MMC_SDHCI=y
|
|
CONFIG_MMC_SDHCI_ADMA=y
|
|
CONFIG_SPL_MMC_SDHCI_ADMA=y
|
|
CONFIG_MMC_SDHCI_AM654=y
|
|
CONFIG_MTD=y
|
|
CONFIG_DM_SPI_FLASH=y
|
|
CONFIG_SPI_FLASH_SFDP_SUPPORT=y
|
|
CONFIG_SPI_FLASH_SOFT_RESET=y
|
|
CONFIG_SPI_FLASH_SOFT_RESET_ON_BOOT=y
|
|
CONFIG_SPI_FLASH_SPANSION=y
|
|
CONFIG_SPI_FLASH_S28HX_T=y
|
|
CONFIG_PHY_TI_DP83867=y
|
|
CONFIG_PHY_FIXED=y
|
|
CONFIG_TI_AM65_CPSW_NUSS=y
|
|
CONFIG_PHY=y
|
|
CONFIG_PINCTRL=y
|
|
CONFIG_SPL_PINCTRL=y
|
|
CONFIG_PINCTRL_SINGLE=y
|
|
CONFIG_POWER_DOMAIN=y
|
|
CONFIG_TI_SCI_POWER_DOMAIN=y
|
|
CONFIG_DM_REGULATOR=y
|
|
CONFIG_SPL_DM_REGULATOR=y
|
|
CONFIG_DM_REGULATOR_FIXED=y
|
|
CONFIG_SPL_DM_REGULATOR_FIXED=y
|
|
CONFIG_DM_REGULATOR_GPIO=y
|
|
CONFIG_SPL_DM_REGULATOR_GPIO=y
|
|
CONFIG_K3_SYSTEM_CONTROLLER=y
|
|
CONFIG_RESET_TI_SCI=y
|
|
CONFIG_DM_RTC=y
|
|
CONFIG_RTC_EMULATION=y
|
|
CONFIG_DM_SERIAL=y
|
|
CONFIG_SOC_DEVICE=y
|
|
CONFIG_SOC_DEVICE_TI_K3=y
|
|
CONFIG_SOC_TI=y
|
|
CONFIG_SPI=y
|
|
CONFIG_DM_SPI=y
|
|
CONFIG_CADENCE_QSPI=y
|
|
CONFIG_SYSRESET=y
|
|
CONFIG_SPL_SYSRESET=y
|
|
CONFIG_SYSRESET_TI_SCI=y
|
|
CONFIG_FS_FAT_MAX_CLUSTSIZE=16384
|
|
CONFIG_EFI_SET_TIME=y
|
|
|
|
#include <configs/k3_efi_capsule.config>
|
|
#include <configs/am62x_a53_usbdfu.config>
|