Enable support for PCIe based xHCI USB 3.0 driver and USB mass
storage support on Retronix R-Car V4H Sparrow Hawk board .
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
Enable support for Winbond SPI NOR on Retronix R-Car V4H Sparrow Hawk board,
this is required to support W77Q51NW on new board revision EVTB1 operational.
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
Enable support for R-Car Gen4 PCIe controller and NVMe storage
on Retronix R-Car V4H Sparrow Hawk board .
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
The CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0xeb300000 does not make it into
board .config on either R-Car V4H White Hawk or Sparrow Hawk, remove
this configuration option. The early SPL stack is however pointing
into the RT-VRAM and may corrupt payload loaded into the RT-VRAM by
the BootROM. Set the early SPL stack at fixed location at the end of
System RAM instead, where it cannot interfere with the payload loaded
into RT-VRAM.
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
Add Retronix R-Car V4H Sparrow Hawk board based on Renesas R-Car V4H ES3.0
(R8A779G3) SoC. This is a single-board computer with single gigabit ethernet,
DSI-to-eDP bridge, DSI and two CSI2 interfaces, audio codec, two CANFD ports,
micro SD card slot, USB PD supply, USB 3.0 ports, M.2 Key-M slot for NVMe SSD,
debug UART and JTAG.
DT is imported from Linux next commit:
a719915e76f2 ("arm64: dts: renesas: r8a779g3: Add Retronix R-Car V4H Sparrow Hawk board support")
Signed-off-by: Marek Vasut <marek.vasut+renesas@mailbox.org>
